page 1 of 3 www.pduke.com 2014/4/30 fed30w series 30 watts dc-dc converter input specifications input voltage range 24vdc nominal input 48vdc nominal input 9 ~ 36vdc 18 ~ 75vdc input filter pi type input surge voltage 24vdc input 48vdc input 50vdc 100ms, max. 100vdc 100ms, max. input reflected ripple current 20map-p start up time nominal input and constant resistive load power up remote on/off 30ms 30ms start-up voltage 24vdc input 48vdc input 9vdc, max. 18vdc, max. shutdown voltage 24vdc input 48vdc input 8vdc 16vdc remote on/off (note 5) (positive logic)(standard) (negative logic)(option) dc-dc on dc-dc off dc-dc on dc-dc off open or 3v < vr < 12v short or 0v < vr < 1.2v short or 0v < vr < 1.2v open or 3v < vr < 12v input current of remote control pin nominal input -0.5ma ~ +0.5ma remote off state input current nominal input 3ma environmental specifications -40oc to +50oc (without derating) operating ambient temperature +50oc to +85oc (with derating) maximum case temperature 105oc storage temperature range -55oc to +125oc over temperature protection 115oc thermal impedance (note 6) nature convection nature convection with heat-sink 12oc/watt 10oc/watt thermal shock mil-std-810f vibration mil-std-810f relative humidity 5% to 95% rh emc characteristics emi (note 7) en55022 class a esd en61000-4-2 air contact 8kv 6kv perf. criteria a radiated immunity en61000-4-3 10 v/m perf. criteria a fast transient (note 8) en61000-4-4 2kv perf. criteria a surge (note 8) en61000-4-5 1kv perf. criteria a conducted immunity en61000-4-6 10 vr.m.s perf. criteria a output specifications output power 30 watts max. voltage accuracy 1% voltage adjustability single output 10% minimum load 0% line regulation ll to hl at full load 0.2% load regulation no load to full load single dual 0.5% 1% cross regulation (dual) asymmetrical load 25% / 100% fl 5% ripple and noise 20mhz bandwidth (measured with a 1uf/50v mlcc) 1.5-5.1vo 100mvp-p 12-15vo 150mvp-p temperature coefficient 0.02% / oc, max. transient response recovery time 25% load step change 250 s over voltage protection zener diode clamp 1.5v 2.5v 3.3v 5.0v & 5.1v & 5v 12v & 12v 15v & 15v output output output output output output 2.0v 3.3v 3.9v 6.2v 15v 18v over load protection % of fl at nominal input 150 % short circuit protection continuous, automatics recovery general specifications efficiency see table isolation voltage input to output input (output) to case 1600vdc min. 1minute 1600vdc min. 1minute case grounding connect case to -input with decoupli ng y cap isolation resistance 500vdc 10 9 ohms, min. isolation capacitance 1500pf, max. switching frequency 430khz 10% safety approvals iec60950-1, ul60950-1, & en60950-1 case material nickel-coated copper base material fr4 pcb potting material epoxy (ul94 v-0) dimensions 2.00 x 1.00 x 0.40 inch (50.8x 25.4 x 10.2 mm) weight 30.5g(1.07oz) mtbf (note 1) mil-hdbk-217f 1.288 x 10 6 hrs. t e c h n i c a l s p e c i f i c a t i o n all specifications are typical at nominal input, ful l load and 25oc otherwise noted features ? 30 watts maximum output power ? output current up to 8.5a ? standard 2.00 x 1.00 x 0.40 inch ? high efficiency up to 91% ? 4:1 ultra wide input voltage range ? six-sided continuous shield ? fixed switching frequency ? ul60950-1, en60950-1, & iec60950-1 safety approvals ? ce marked ? compliant to rohs ii & reach options negative logic remote on/off description the fed30w series offer 30 watts of output power fr om a 2 x 1 x 0.4 inch package. fed30w series have 4:1 ultra wide input vo ltage of 9 ~ 36 and 18 ~ 75vdc. the fed30w have features 1600vdc of isolatio n, short circuit protection, over-current protection, over-voltage p rotection, over-temperature protection and six sided shielding . applications wireless network telecom/datacom industry control system measurement semiconductor equipment
page 2 of 3 www.pduke.com 2014/4/30 fed30w series 30 watts dc-dc converter output current no load (2) model number input range output voltage min. load max. load output (3) ripple & noise input current eff ( 3 ) (%) capacitor ( 4 ) load max. fed30-24s1p5w 9 ~ 36 vdc 1.5 vdc 0ma 8500ma 100mvp-p 70ma 80 20000 f fed30-24s2p5w 9 ~ 36 vdc 2.5 vdc 0ma 8000ma 100mvp-p 70ma 83 20000 f fed30-24s3p3w 9 ~ 36 vdc 3.3 vdc 0ma 7500ma 100mvp-p 70ma 86 20000 f fed30-24s05w 9 ~ 36 vdc 5.0 vdc 0ma 6000ma 100mvp-p 105ma 88 14400 f fed30-24s5p1w 9 ~ 36 vdc 5.1 vdc 0ma 6000ma 100mvp-p 105ma 88 14400 f fed30-24s12w 9 ~ 36 vdc 12 vdc 0ma 2500ma 150mvp-p 20ma 89 3000 f fed30-24s15w 9 ~ 36 vdc 15 vdc 0ma 2000ma 150mvp-p 30ma 89 2000 f fed30-24d05w 9 ~ 36 vdc 5vdc 0ma 3000ma 100mvp-p 90ma 88 3000 f fed30-24d12w 9 ~ 36 vdc 12vdc 0ma 1250ma 150mvp-p 25ma 87 2000 f fed30-24d15w 9 ~ 36 vdc 15vdc 0ma 1000ma 150mvp-p 25ma 87 1300 f FED30-48S1P5W 18 ~ 75 vdc 1.5 vdc 0ma 8500ma 100mvp-p 30ma 80 20000 f fed30-48s2p5w 18 ~ 75 vdc 2.5 vdc 0ma 8000ma 100mvp-p 45ma 84 20000 f fed30-48s3p3w 18 ~ 75 vdc 3.3 vdc 0ma 7500ma 100mvp-p 45ma 86 20000 f fed30-48s05w 18 ~ 75 vdc 5.0 vdc 0ma 6000ma 100mvp-p 65ma 88 14400 f fed30-48s5p1w 18 ~ 75 vdc 5.1 vdc 0ma 6000ma 100mvp-p 65ma 88 14400 f fed30-48s12w 18 ~ 75 vdc 12 vdc 0ma 2500ma 150mvp-p 60ma 90 3000 f fed30-48s15w 18 ~ 75 vdc 15 vdc 0ma 2000ma 150mvp-p 50ma 91 2000 f fed30-48d05w 18 ~ 75 vdc 5vdc 0ma 3000ma 100mvp-p 50ma 88 3000 f fed30-48d12w 18 ~ 75 vdc 12vdc 0ma 1250ma 150mvp-p 15ma 88 2000 f fed30-48d15w 18 ~ 75 vdc 15vdc 0ma 1000ma 150mvp-p 15ma 88 1300 f note 1. mil-hdbk-217f @tc=70 oc, full load. 2. typical value at nominal input voltage and no load . 3. typical value at nominal input voltage and full lo ad. 4. test by minimum input and constant resistive load. 5. the ctrl pin voltage is referenced to -input. 6. heat-sink is optional and p/n: 7g-0020c-f. 7. the fed30w series standard module meets en55022 cl ass a and class b with external components. for more detail information, please contact with p- duke. 8. an external filter capacitor is required if the mo dule has to meet en61000-4-4,en61000-4-5. the filter capacitor power mate suggest: 24 vdc inp ut : nippon chemi-con ky series, 330 f/50v. 48 vdc input : nippon chemi-con ky series, 220 f/100v. caution: this power module is not internally fused. an inpu t line fuse must always be used. efficiency (%) fed30-48s05w efficiency vs input voltage 85 87 89 91 93 95 18 24 30 36 42 48 54 60 66 72 75 input voltage (v) fed30-48s05w efficiency vs input voltage efficiency (%) fed30-48s05w efficiency vs output load 50 55 60 65 70 75 80 85 90 10 20 30 40 50 60 70 80 90 100 % of full load fed30-48s05w efficiency vs output load 0 20 40 60 80 100 120 -40 -20 0 20 40 60 80 100 120 ambient temperature( ) output power (%) 64 fed30-48s05w derating curve with heat-sink 0 20 40 60 80 100 120 -40 -20 0 20 40 60 80 100 120 ambient temperature( ) output power (%) fed30-48s05w derating curve 55
page 3 of 3 www.pduke.com 2014/4/30 fed30w series 30 watts dc-dc converter mechanical drawing pin connection pin single dual 1 + input + input 2 - input - input 3 ctrl ctrl 4 + output + output 5 - output common 6 trim - output 1. all dimensions in inch (mm) tolerance: x.xx0.02 (x.x0.5) x.xxx0.01 (x.xx0.25) 2. pin pitch tolerance 0.01(0.25) 3. pin dimension tolerance 0.004 (0.1) output can be externally trimmed by using the method shown below. external output trimming 6 5 trim up 6 4 trim down r u r d
|
